SYNERKON LLP - ACCURATE, LIGHTWEIGHT AND RELIABLE ANALYZERS OF METALS AND ORES
At the stand of SYNERCON LLP, devices for solving problems of determining the chemical composition of metals, alloys and ores – X-ray fluorescence analyzers X-Met will be presented.
It is characterized by high accuracy of analysis, ease of operation and minimal requirements for the level of operator training. With reliable hardware and intuitive software, any operator can get reliable results that meet the most stringent regulations and standards.
Technical specifications:
- A wide range of element measurements from Mg to U.
- The analysis time is 2-5 seconds.
- An updated high-resolution SDD detector for accurate analysis of complex alloys, powders, and ferroalloys.
- Ready to work in a few seconds, does not require consumables and calibration when turned on.
- Low weight, ergonomic design and battery life of 10-12 hours make the device optimally efficient.
- IP 54 dust and water protection for operation in different climatic conditions.
- Protective mesh for chip analysis.
- Automatic sample compensation allows measuring wire from 1 mm, fasteners, chips, hardware, welds, ferroalloys, powders.
- Built-in software for storing up to 100,000 results with the ability to upload the results to a USB drive in the form of a user-formatted report.
Schedule a meeting with the company at the Mining & Metals Central Asia 2024 exhibition.
September 17-19, 2024
Almaty, Kazakhstan
Your entrance ticket is at the link.
Invite partners and colleagues in the industry to join you at the exhibition. Share the promo code MMCQ5GGKX8
- Hits: 130